Hale TPM Sistem Bedienungsanleitung PDF herunterladen

Hale Products Inc. • A Unit of IDEX Corporation • 700 Spring Mill Avenue • Conshohocken, PA 19428

Phone: 610/825-6300 • Fax: 610/825-6440 • 800-220-4253 • www.haleproducts.com

RETROFIT

If you are retroﬁtting the TPM System to an older pump, call the

Hale Pump Service Department, with the pump Serial Number to

verify that the pump has the proper openings for the TPM System

before attempting retroﬁt.

PMD CONTROL VALVE

Cut the mounting holes in the truck panel as shown on Plate

No. 742C. The new PMD Control Valve must be located higher

than the top of the midship pump to allow for proper drainage

Install the indicator bracket assembly (519-0071-10-0) to the

PMD Control Valve by placing the slot in the bracket and

white pressure indicator over the pin in the PMD Control Valve.

The (4) mounting holes in the indicator bracket should align

with the tapped holes in the PMD Control Valve. The top view

of the PMD Control Valve with the indicator bracket assembly

installed is shown in Figure 1.

The PMD Control Valve assembly can now be mounted to the

truck panel as shown in Figure 2. The PMD Control Valve

Assembly is installed on the inside of the truck panel while the

instruction plate is on the outside. Attach the instruction plate to

the PMD Control Valve Assembly using the (4) 3/4-20 x 5/8 Lg.

Phillips Head Screws (018-1205-44-0). Tighten securely.

Attach the adjusting handwheel (512-0070-00=0) to the PMD

Control Valve Shaft using the screw (018-1214-45-0) and lock

nut (110-1205-11-0) provided. Turn the adjusting handwheel in

both directions to verify that the pressure indicator moves freely

to both extremes. If the pressure indicator does not move freely,

check for binding from the indicator lock nut (110-1008-06-0).

There should be approximately a 1/64-1/32 space between the

washer (097-0750-01-0) and the lock nut.

FIGURE 2

FIGURE 1

TPM SYSTEM INSTALLATION & OPERATION MANUAL

(Manual Part No. 101-0850-08-0)

1 2 3 4 5 6 7 8